| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| LMII binding cutter question http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=48819 |
Page 1 of 1 |
| Author: | guitarradTJ [ Sat Jan 07, 2017 4:28 pm ] |
| Post subject: | LMII binding cutter question |
Hi guys, I'm buying the binding cutter from LMII along with a few of the bearings. My question is ( it may be a dumb one) what's the difference between the long and short shank.... Besides the length haha. Just wondering which one I should get. Thanks in advance! Sent from my R1 HD using Tapatalk |
|
| Author: | Tim Mullin [ Sat Jan 07, 2017 6:41 pm ] |
| Post subject: | Re: LMII binding cutter question |
Depends a bit on your particular laminate trimmer, but if you're using an auxiliary base with a "donut" on yours, then you'll probably want the longer shank. Sent from my iPad using Tapatalk |
|
| Author: | Imbler [ Sat Jan 07, 2017 7:49 pm ] |
| Post subject: | Re: LMII binding cutter question |
Yep, even with the long one, I would like to have a smidgen more shaft engagement in the router, MIke |
|
| Author: | guitarradTJ [ Sat Jan 07, 2017 8:15 pm ] |
| Post subject: | Re: LMII binding cutter question |
Got it, I haven't gotten the laminate trimmer yet, but I'll get the long shank. Thanks! Sent from my R1 HD using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|